Kitchen Sink Mixer Tap with Hoses - Stainless Steel 360° Monobloc Single Lever Swivel Spout,High Arc Mono Basin Faucet,with 1/2'' Female for UK Standard Fittings

Great product and great price too. Fast delivery and well packaged. Works fantastic, looks very nice too. Works great and easy to fit. Well worth getting this very good product.

This is a very good tap for a very good price. It is easy to fit and works perfectly. It’s no frills but looks good for any standard sink. I was very impressed!

Kitchen taps are generally hideously over-priced but not this one.It does rotate through 360 degrees which is what I required - but wasn't clear in the listing - but it's Amazon - so if it's no good then send it back.Now the important parts forthe Amazon customer.The sink is not included and you have to supply your own water.The hoses are 1/2" Bsp - not any made up Chineesium size either.

Bad quality , to start with , but I mean it’s cheap and it does the job

Unless you are a professional plumber, and have fitted one of these before, do not buy.It was cheap, came well packaged and the tap itself is OK.However, fitting it was a nightmare. Having removed the old monoblock tap, I thought that fitting this would be easy. No instructions with it at all, but I thought that it was a question of screwing in the two flexi pipes and dropping it into the hole. Wrong!First problem was deciding which of the two holes to fit the pipes to - no C/H indication on the tap body. Eventually screwed both in and, by blowing down them and moving the mixer knob I found which was cold and which was hot! Sorted I thought. However the small hex heads on the pipe nut were 11.4 mm A/F. Not having a 11.4mm spanner, I had to angle grind one to fit. The nut on the cold flexi dissapears right down within the body of the tap, so, unless you have a very small well fitting spanner, you can’t tighten. Another job for the angle grinder!With the pipes screwed on, I tried to fit the threaded sleeve to the tap body, finding that you can't do that with both pipes fitted! So, removed one, fitted the sleeve. The threaded sleeve itself will only go on one way, with the short length of thread towards the tap, so, having got it wrong first time, the second pipe had to come off again! With that sorted I lowered the tap into the hole, and went to fit the threaded plastic supporting nut. Guess what, you can’t fit this with both pipes connected. Once again, removed a pipe, fitted the nut and tried again. If you have’nt got both of the plastic sealing washers in place by this time, another strip down will be called for.After many hours and a lot of bad language the tap was fitted.Well, it was cheap!!!!!”

Fantastic quality product for a very reasonable price x

Swapped this tap for a more expensive but unsuitable, lower quality tap fitted in my new caravan. Used existing fittings albeit the new tap came with them. The best thing is the ingenious way the tap fits to the sink. So much easier than other taps I've fitted. No instructions supplied but easy to figure out.

The tap works well and is easy to fit. There is a click that some might find annoying when you turn the head and its very light so have to make up your own mind if thats a good or a bad thing.