FLYCLE 8x6.5 Wheel Spacers 2'' for 1994-2011 Ram 2500 3500, 8x165.1mm 8 Lug Forged Wheel Spacer for 1988-1996 F250,1992-1997 F350 with 9/16-18 Studs & 126.15mm Bore

Got these for a 2016 ram 2500 spacers good quality I use the lite for the factory studs. I torque down the spacer to factory specs. Then I took down the wheels to factory specs definitely gave the truck a really good look I do heavy hauling, And deliver firewood. I I haven’t had any issues with the spacers and I haven’t had to re-torque them. I hope my pictures show buyers what you’re getting. Thank you!!!

After a bunch of research, I took a chance that spacers for a 1988-1998 F-250 everywhere else would also fit my E350 through Amazon even though the automatic cross reference program didn’t think so. Fit is perfect. Material shows absolutely no flaws. With a small shim ring they could be as hub centric as the original wheel fit. Without I suppose that if you were not careful about the tightening sequence there could be a centering issue. Is seriously doubt there will be any movement after proper installation with the supplied thread lock and proper torque. The two-inch spacer cleared the studs fully. The nuts shipped on the spacer’s lugs are what attaches it to the hub. They used a 13/16 wrench so the socket would clear. The small clearance of that socket confirmed each hole was perfectly aligned. I wish I had ordered capped nuts for appearance but had to use the original ones. What these did for me it bring the wheels on my camper out to where the body manufacturer apparently intended without adding duals. The chassis has a full floating axel and the wheel center is still not out to where it would be with duals so I don’t believe they should adversely affect the bearings. While the literature may not be fully Americanized I did not find any quality issues.

I purchased a set of these wheel spacers for the rear axle of my 1994 Ford F350 to get my rear axle to match the width of my front axle. Worked great for me, even turning 39.5x16.50R16 on beadlocks

I order two sets of these to mount my wheels to my truck when I opened the boxes the one set came with the lugs to mount the to the truck the other set didn’t have lugs at all. Will be returning the one set. Slows down my build process

Went on easy! Had to trim back lugs just to where the thread starts. They look great.

Make sure you have the right sockets

Overall these are middle of the road spacers. When buying less expensive wheel pacers and/or adapters the studs and nuts are the first things that the manufacturers cut corners on. On the first(and only) spacer of four, I could only get three out of eight to torque to spec. And those three required way too much effort to get done. The other five lugs spun the studs and never got to torque spec. I stopped trying after the effort involved with the first three and seeing how the others where behaving. These aren't bad for the price, just keep in mind that you will want to buy better quality studs and nuts to install before use.

Lug nuts that come with are to big as others are for 3/4 socket to fit inside the lug hole on spacer to bolt to vehicle. These came with lugnuts for a 21mm socket and can not fit socket into lug hole and had to go buy all new lugnuts to use them. Yes i know its cheap and get what you get but have ran several amazon spacers on my trucks and this is only set ive ever had this issue with.